Operating Instructions for Filling the Bath with Hot Water
If you wish to fill the indoor or outdoor baths with hot water at the house, please check the following instructions.
＊For FUKUOKA/KITAKARUIZAWA BASE-S/M hot water filling operation, please use the water filling button provided in the bathroom.
※Please use the faucet on the top of the bathtub to directly fill the bathtub with hot water.
Start heating water
Select the room with hot water heating from the home screen of the iPad provided. *It is usually located in the bathroom.
Select the hot water heater from the list of devices. (*Some rooms may have more than one hot water heater (indoor bath, outdoor bath, etc.), so please select the one you wish to use for hot water heating.
Select the one you want to fill with hot water .
＊Hot water temperature cannot be changed. After filling the tank with hot water, add hot water using the "Add Hot Water" button to adjust the temperature. The temperature for adding hot water can be adjusted using the knob below the button.
＊While water is being supplied, the button to stop hot water heating is displayed. Please select this option only in case of emergency.
＊Once hot water heating is stopped, it cannot be re-started unless the water is drained.
Drainage
After the hot water has been heated, the Drain button will appear.Select to drain the water.
* After the drain button is selected, the button to fill the water with hot water will not appear for a while.Please wait until the hot water heating button appears again when hot water heating becomes possible.